This is the support structure for the arduino, motors and LED lights. The motor's will be hot glued into each hole on the upright structure with fan blades attached to move the boat. The two pieces fit perfectly according to Nick's calculations so they were hot glued together. Josh's measurements were slightly off on the motor structures so Josh used a dremel to widen the hole. Afterwards, the motor fit in perfectly and was hot glued in. The bottom structure was the perfect size for the circuit board to rest on and the screw holes on the board matched up to the screw holes on the structure. Then the fan blades were hot glued to the motor and Josh's dimensions fit perfectly, enabling the fan blades to not hit each other.
No comments:
Post a Comment